SUBSIM Radio Room Forums - Help ! ATI Users, specially X800 series.

SUBSIM Radio Room Forums (https://www.subsim.com/radioroom/index.php)

- Silent Hunter III (https://www.subsim.com/radioroom/forumdisplay.php?f=182)

- - Help ! ATI Users, specially X800 series. (https://www.subsim.com/radioroom/showthread.php?t=86624)

Quote:

Should be available through the display properties "advanced" button.

However if not available try using a third party set of software like Tray Tools or RIVA tuner you can find these at downloads section of http://www.guru3d.com/

Thank you for the reply.I can't find it in the advanced properties.Maybe i should have used the drivers with a Catalyst control center thing instead of control panel?

Anyway,i will try those tools.
Thank you.

Quote:

Originally Posted by U-214

Quote:

May be... i am using the small version with Control Panel instead Control Center like you.

I have the temperature showed into divers panel

Right click on desktop > properties > configuration > Advanced options > and then go to the Override (tm) tab...

There you have temperature and core frecuency.

If not use the programs reccomended by Wolram :up:

Or another one, not so pwerful than ATI Tray Tool, but so good enought > ATI Tool.

Best regards, Red.

I attempt today to install a new time ATI Tray Tool, but no way, SH3 crashes with it after few seconds of play, i attempt to change many settings but no way, always crashes. :hmm:

I back to ATI Tool and Riva Turner. :up:

Thank you Redwine,but apparently my card not being for gamers,isn't supported.There isn't an override option at all.Also i tried the Tray Tools and in available hardware monitor the temperature is grayed out.

Thank you very much for the help though.

Quote:

Originally Posted by U-214

Ahh I should have considered that possiblity - your card does not have a temperature probe so I am guessing even RIVA Tuner prog may not read it but the software still might be worth looking at, maybe a few tweaks it can provide you.

g/l

:lurk:

I have the 5.10 version of ATI's Catalyst drivers. I'm using the Catalyst Control Center. Is there a way I can check the temperature on my card? It is an Abit Radeon RX700-Pro PCI-Express card.

Quote:

Originally Posted by Syxx_Killer

I have the 5.10 version of ATI's Catalyst drivers. I'm using the Catalyst Control Center. Is there a way I can check the temperature on my card? It is an Abit Radeon RX700-Pro PCI-Express card.

Hi Syxx Killer, look the comments for U-214, follow the same tips. :up:

Quote:

Originally Posted by Syxx_Killer

I have the 5.10 version of ATI's Catalyst drivers. I'm using the Catalyst Control Center. Is there a way I can check the temperature on my card? It is an Abit Radeon RX700-Pro PCI-Express card.

Got me here I am using AGP x800XT but would think somewhere within the CCC panel is a temp gauge - later ATi like yours have temp probes built in. Try the display properties method mention a couple posts above. Or through control panel.

Otherwise try this:

http://www.guru3d.com/index.php?page=rivatuner&menu=8

it has a lot but be careful about the functions RIVA is powerful stuff give you ability to mod the registry and hardware - may void a warranty also so check the Guru3D forums first before doing any power user stuff.

But it has a temp monitor and some other simple stuff too that is useful and safe to use.

g/l

:lurk: