I am new to this mod. Just a few questions for clarification:

1. Installation: please correct me if I am wrong. I extract all files in "ARB WideGUI 1920x1080" into the game folder. Extract Tycho files. And run Tycho bat. DO NOT use JSGM mod enabler, correct? The 3.01 hotfix can be applied using JSGM?

2. Based on Tycho's instructions. If we want H.sie patch, we need do that patch first before Tycho's bat file, correct?

3. Is this mod compatible with GWX?

4. Can I still use FM_New Interior mod with this?

Thank you for your work improving the AH widescreen gui!

Can you fix the broken tube selection dial on the attack periscope and uzo?
On the Attack Map screen, toggling the salvo selector between T and S changes the tube dial from single tubes to salvo modes. This is good.
However, on the uzo and attack periscope, this doesn't happen, and the tube dial is not functional. This is bad.

This is particularly important since changing tubes with that dial is the only way I know of to keep the tubes from closing themselves.

Can I use this mod with FM interiors? is there a patch I tried it but the periscope lines are messed up

I remember reading someone had similar issue. But it was with another widescreen gui. What he did was he installed FM-interior first and then the new widescreen gui. But that way, you lose the FM's shortcut key commands. Not sure if you would still be able to move around the sub anymore.

How does one use the chronometer/stopwatch that's draggable from the bottom right corner? I can't seem to start or stop it.

it shows the main chronometer , when that one is working the draggable one works too , the idea is to watch the chronometer in other menus also without the need to switch to periscope, for example .

Just was able to get this thing install. This is an awesome mod and has a lot of potential. Please keep up your good work:up:

Unfortunately this is missing all the fixes that Izgud made for the Ahnenerbe gui!

It has doubled TDC dial labels in the attack map, which he had fixed.
Crew talks when using pgup or pgdn to adjust periscope, which he had fixed.

It lacks the added RPM chart at the hydrophone station.

I haven't checked the RAOBF mark (which was wrong in Ahnenerbe), but I suspect it will be wrong here too.

I also notice that there are two sets of reticles inside the UZO, and that the scale of the reticles in the Obs scope and Attack scope are wildly different.

Impossible to get it working correctly.

GWX3 no mods, installed to the letter, my nav map is screwed up in 2 parts by the middle screen, and my sub is showing even not on sea...

Don’t Understand, i patched it after the H.sie patch as commanded.

Back with Ahnenerbe GUI wich is working perfect.

You done something wrong. Try removing the patch with Remove.bat and then again reaplying it. Fixed for me

Thanks, i’ll Give a try again :up:

Still not working. Tried everything possible.

All gui is fine except the nav map wich is unplayable. And without nav map... :timeout:

No big deal though, Ahnenerbe is running fine.

@Brodaga222 Great mod, works fine for me. But would it be possible to add a full functional RAOBF and the attack disk? greetings .....

welcome aboard!
 

thx Aktungbby

So I found the attack disk ... but the disk only appear when a targed is locked. Is this intended? I think this is a huge limitation of the disk.