That is strange, very strange, since nobody else had that problem.... look at the screenshots in the first post... :hmmm:

There is something you are not doing right in the process...
Take a look at these fresh screenshots right out the oven just to show everything runs smoothly.... Just downloaded the mod again, installed it following the instructions, enabled it via JSGME and there you go...


https://i.postimg.cc/65ytdCcP/SH3-Im...-48-14-456.jpg


https://i.postimg.cc/MZszM97R/SH3-Im...-48-40-339.jpg


https://i.postimg.cc/QxwsSVnd/SH3-Im...9-49-47-56.jpg


https://i.postimg.cc/SKp4F340/SH3-Im...-51-29-839.jpg


https://i.postimg.cc/13FSdPLc/SH3-Im...-51-58-373.jpg

Ok. Evidently it is a problem with my setup or my instalation. If I find the solution, I will come back in case someone else has the same thing.

Anyway, thank you very much for your attention. :salute:

All I can do is give you a couple of advises:
1.- Download again the ARB mod (just in case)
2.- While in the set up process, take your time and don't rush to avoid mistakes reading the Readme file step by step.


With that, for sure you will do it successfully!


:Kaleun_Salute:

Heya! Any chance we could get an updated download link for the mod? Thanks!

Thanks so much!

Just in case, latest version is V8 and the d/l link is:

https://www.mediafire.com/file/tj9h0...lex_V8.7z/file

I have the same problem. No range finder in the lens and text if off to the right when clicking on range or speed in the notepad.
:Kaleun_Salute:

From what I found out, the notepad problem is caused by the option "Disable hardcoded scopes reticle" included in the automatized Tycho v3 SH3 Patch. Just don't patch nor move the sh3.exe file from the main folder. The Onealex mod has the parameters for widegui already integrated. Just activate the CAP mod with the data file only. Worked for me. Simple as that. - Even though I don't use the notepad, I like everything working properly. :03:
:Kaleun_Salute:

Quick Question -



I'm seeing an offset between the progress bar and the location where it is expected in the background on the current version of OneAlex and the v8 WideGUI. Is this a known issue? I can post screenshots if it is of value.


Thank you,


Mike

Disregard - it turned out to be an issue caused by my attempts to run at my screen's native resolution. Once I reverted to native OneAlex and re-selected the ARB Gui inside JSGME it worked as expected :)