You must be registered with this forum to download files. If you are registered and getting this message, then the Downloads section is experiencing heavy load volumes and has been temporarily restricted to members who are in the Subsim Navy (donors). Please try again later.
This Dose exactly what the above mod dose but also hides the Enemy Sonar Sensor Values
as you wont know the enemy's sensor levels it will also mean using the identification book to look up what sensors are equipped on the various contacts to gauge their sensor capability's
this plus experience of the vessels over time will give a good added depth to judging when you are in danger of being detected
also you will need to take in to account the conditions more so ect ;
is their a thermal layer & Duct
how loud is the back ground ocean noise
how close is the ocean floor
& how loud your own vessel is
as these factors will matter in how close you can safely get without fear of being detected
as not knowing what the enemy can see Sensor wise will make it harder to know when you in danger of being Detected
Choices are :
50 ft on arrows + SnS Comp Hide
100 ft on arrows + SnS Comp Hide
3.)--------Installing
this mod requires Epic Mod 2.27 to be installed first
and will benifit if you also use my 5.6 - Epic mod ver 2.27 tweaks Ver 7 VII as these two mods are designed as a pair on construction
First Unzip------ this file
its going to be best to replace the original file without mod installer as this can cause problems if too many Assembly
files are stacked so
To install simple replace the ( Assembly-CSharp )
so find this path :
Cold Waters\MODS\5.6 - Epic mod ver 2.27 tweaks Ver 7 VII\ColdWaters_Data\Managed
and delete ( Assembly-CSharp ) then pop the one you want in replacement files are :
" 50 FEET Helm Depth Mod folder " ( Standard Cold waters Version Depth )
" 100 FEET Helm Depth Mod folder " ( Original Mod Version )
"SnS Hide + 50 FEET Helm Depth Mod folder" ( Standard Cold waters Version Depth + SnS Hidden )
"SnS Hide + 100 FEET Helm Depth Mod folder" ( Original Mod Version + SnS Hidden )
IMPORTANT !!!!!!! Use the mod installer to remove ( 5.6 - Epic mod ver 2.27 tweaks Ver 7 VII ) then RE-ENABLE it before
launching Cold Waters. after swapping the ( Assembly-CSharp ) File.
enjoy
3.)-------Help
any problems just message me on Subsim
steel shark
Images
None
You must be registered with this forum to download files. If you are registered and getting this message, then the Downloads section is experiencing heavy load volumes and has been temporarily restricted to members who are in the Subsim Navy (donors). Please try again later.
