How to craft an Atack disk

[Spuky05]

Hey Guys,
for Immersion and for Wolfpack i wanted to build an Attack disk. downloaded a file with the pieces but now i have a Major Problem: I dont know how to build the transparent parts because i just have a regular Printer. If you have Ideas for a Workaround or something please write it here.

Greetings Suky05

[propbeanie]

Not an endorsement of the shopping site (unless you go through the SubSim store to it), but most printers can use these:

Transparency Sheets (https://www.amazon.com/inkjet-transparency-film-Office-Products/s?k=inkjet+transparency+film&rh=n%3A1064954)

Look up what you can use in your printer on the printer manufacturer's site. I found some a good while back that were rather "thick", and could hold their shape rather well. My main problem with them was that my printer uses soy-based ink that is not water-proof... don't set your coffee cup on top of anything printed with soy ink, because it will run if not "set" with a fixative... :03:

[Spuky05]

Thank you! I´m gonna try this :yeah: