CTD when moving PO to control room

[junkman]

Using SH3 Commander I selected a new PO from list to crew list. While in game I moved Po from damage control to helm got CDT. Using CWX, with lite mods. Any time I move this one PO to helm or bridge I get CDT, is this a bug? Or should I just remove Po?

[XenonSurf]

This crew transfer CTD is in the list of unresolved SH3 bugs (can be found in the stickies somewhere and in the GWX manual), I don't know if SH3 Commander will avoid it. Just don't do this kind of transfer, chose an alternative method.

Do you have installed the special files necessary to run SH3 Commander with GWX?

[junkman]

Yes I have been using over a year, but first time with this bug.

[XenonSurf]

Yes I have been using over a year, but first time with this bug.

Just an idea, but maybe problems arise because you use SH3 Commander and after that you are starting the game normally without it. (?)

I have not seen your bug yet but I've not been playing GWX for very long; I didn't buy new crew members recently, so I don't recall any problems. I play WAC5 and I usually move the crew between different sub compartments when needed in-game. I only use SH3C for date changes and changing patrol area in rare cases.

I think the "unresolved bug" that I mentioned above is not related to your problem, it can happen when using the generic crew distribution buttons for a situation (2 of them are: normal navigation, attack setup which will fill the torpedo room). You can also double-click a sub station to fill the room I think.

[junkman]

Well I did start with SHCdr and then short cut for SH3 some times between patrols. But I only move crew with mouse not buttons or quick links. Also I deleted Po which was the problem between patrols and acquired a new PO (free) did not pay. Same result. Thank for your help.