sixcoins
09-03-12, 10:24 AM
I've seen a lot of tutorial videos, and they always seem to have a compass on their ruler.... so they can always see what bearing line they are drawing...
I cannot see that. I have to use a protractor see a bearing, then I have to mark that location, then erase the protractor, then draw a line from my u-boat to the mark I previously drew..
And I have to do that for every line I make (if it's a long range line).
This is time consuming and not a little bit frustrating.
I can't find any such setting in SHIII.
How do I get that compass at the end of my ruler line?
Thanks in advance.
Six.
I cannot see that. I have to use a protractor see a bearing, then I have to mark that location, then erase the protractor, then draw a line from my u-boat to the mark I previously drew..
And I have to do that for every line I make (if it's a long range line).
This is time consuming and not a little bit frustrating.
I can't find any such setting in SHIII.
How do I get that compass at the end of my ruler line?
Thanks in advance.
Six.