TMO - Cycle Tubes key W only works on fwd tubes on Sargo class?

[timmyg00]

recently installed TMO/RSRDC/OTC, and my Cycle Tubes key W only works on fwd tubes on Sargo class. Which key cycles the aft tubes?

Thanks

TG

[Hylander_1314]

Go to your SH4 \ Data \ CFG \ Commands.cfg file.

There is a long list of commands, so use the Find option, under edit, or I think it CTRL+C on the keyboard.

Look for the "Y" with quotes. The one you want will say Cycle Aft Tubes.

At the front of the line, it is commented out with ";". Remove the ";" from the front of the line, and you will have the Y key back for cycling the tubes.

You can do the same with the letter "E", for a key command to blow ballast.

That should get'cha back in business. :up:

[WernherVonTrapp]

Go to your SH4 \ Data \ CFG \ Commands.cfg file.

There is a long list of commands, so use the Find option, under edit, or I think it CTRL+C on the keyboard.

Look for the "Y" with quotes. The one you want will say Cycle Aft Tubes.

At the front of the line, it is commented out with ";". Remove the ";" from the front of the line, and you will have the Y key back for cycling the tubes.

You can do the same with the letter "E", for a key command to blow ballast.

That should get'cha back in business. :up:Ahh, thanks Hylander_1314.:up: I've had the same problem but just was never concerned enough about it to ask.:|\\

[Hylander_1314]

No problem Werner. Glad it's useful!

If you check the TMO FAQ, it led me to the Commands.cfg file, and so I poked around in there just looking up words or key commands with the quotes, and it was rather enlightening to say the least.

Amazing what we do when we're board...............:doh:

Although a 5,000 sq. ft. garden is taking up a lot of time now! Not much time to be board for sure! Especially keeping the fury critters out. Cute, yes, but not growing it for them!

[mobucks]

By default, the "E" key is used to cycle aft tubes in TMO.

[Hylander_1314]

These are right out of the Command.cfg file. The option is there for either.

[Cmd323]
Name=Cycle_torp_tube
Ctxt=1
;Key0=0x57,,"W"
;Key0=0x59,,"Y"

[Cmd324]
Name=Cycle_fore_torp_tube
Ctxt=1
;Key0=0x59,s,""
Key0=0x57,,"W"

[Cmd325]
Name=Cycle_aft_torp_tube
Ctxt=1
;Key0=0x59,c,""
Key0=0x59,,"Y"
;Key0=0x45,C,"E"

Separating them by a few keys works better for my fat finger key strokes.

[Cmd202]
Name=Emergency_surface
Ctxt=1
MnID=0x3F230003
Str=1034
Key0=0x45,C,"E"

With the Emergency Surface key next to the tubes key, it forces me to practice accuracy on the keyboard.

But I have had a couple unexpected situations, shall we say?

[timmyg00]

Thanks folks!

TG

[Hylander_1314]

:up: