Adding GWX Cfg files to SH3 Commander?

[Lane]

I have SH3 Commander 3.1.2 and GWX 2.1 Installed again.
I downloaded the GWX 2.1 cfg files for SH3 CMD 3.0
And have been installed and copy files manual to my SH3 CMD. Folder.
Step 1. Copy the 5 GWX files to my SH3 Cmd Cfg Folder Replacing 5 files.
Step 2. Add the Air Folder the 907 Flotilla Data Folder Hope this was right?
Step 3. I am confused?? About the VIIC41 Folder in the U Boat Folder??
Do I Replace the VIIC41 folder with the GWX VIIC41 Folder? or copy the GWX
Folder into the orignal VIIC41 CMD folder then I have two VIIC41 Folders??
The new GWX VIIC41 and the orignal SH3 VIIC41 Folder. Something just doesn't Look right.:damn: Could sombody help me on the VIIC41 Install. The Last step.:D
Thank's
Lane.

[nirwana]

It goes into the cfg folder of sh3com therefor u have 1 x VIIC41-folder in "../u-boat/" form the installation of sh3com and another one in "../cfg/" after copying the extra cfg files as described in the readme.txt file.

[bigboywooly]

Tis my fault that

I should have said copy the contents into the data folder
Overwriting the Cfg\907 Flotilla Data and Submarine folders ( from memory )

The 907 folder will put Med skins on the aircraft when in the Med automatically
The Viic\41 will automatically give you the improved VIIC41 model when chosen

:oops:

[Lane]

Big Boy,

Sent you a PM. May be you help me.?

Regards
Lane

[bigboywooly]

Aye
Replied