A little Help from my friends

[Doolar]

about 2 years I started playing SH III , so I insalled it + numerous other Mods like GWX , the Torpedo Damage Mod , the Longer Wakes Mod and a few others that came along . I just can't remember the correct order in which to install these mods and which mod I could use now to get the most out'a this game . Any suggestions would help ... thanx , Doolar U-27

[U49]

Hi,

See my signature, for what I recommend :D
You should start with GWX and and if you want some special mods more, they should
a) be in the GWX compatible version
b) activated (with JGSME) afterwards

The correct sequence now depends either on your list of mods or in the best case does not matter at all.

[melnibonian]

Ideally you want GWX. It's by far the best mod out there and gives you the greatest U-Boat Experience. To install it follow these instructions

Basic Install of GWX

1) Uninstall SH3 via Windows' "Add/Remove programs"
2) Open Windows Explorer and:
- *delete* the folder where you had installed SH3
- *delete* the \My Documents\SH3 folder
3) Reinstall SH3
4) If your SH3 did not come with patch v1.4b already included, install patch v1.4b. Ensure you install the patch that corresponds to your copy of SH3 (Download/DVD/EMEA/US)
5) OPTIONAL: Copy and paste this "clean" install as a backup to avoid the need to follow steps 1-3 if your game becomes corrupt in future
6) Visit the GWX Sticky (available by clicking on our sigs) and download into the SAME folder GWX.exe and the five .bin files. While there grab the v1.03 patch
7) Run GWX.exe and follow the installation prompts
8. Run GWX103.exe and follow the installation prompts
9) SH3 COMMANDER USERS: Visit the GWX Sticky and download the GWX 1.02+ Cfg files for SH3 Commander and unzip the contents DIRECTLY into your SH3 Commander\Cfg folder.

Install of Multiple Versions

1) Complete a fresh install of SH3 + 1.4b as normal.
2) Create a copy of the program folder & rename as required.
3) Install your mod of choice to the renamed version.
4) Create and rename shortcuts as required.
5) Use MultiSH3 to create separate save locations for each install.

SH3 Commander & Multiple Installs

It is recommended to have a separate install of Commander for each different install of SH3.
1) Install SH3Commander and rename the program folder to suit.
2) Rename each SH3Cmdr shortcut as required.
3) You will need to use the l: switch to point SH3Cmdr to the right installation.

Here's an example of the l: switch for dual installs, just tailor it to fit.....

Right click on the SH3Cmdr shortcut & choose properties.

Target
"C:\Program Files\SH3 Commander-GWX\SH3Cmdr.exe" /l:"C:\Program Files\Ubisoft\Silent HunterIII-GWX"

Start in
"C:\Program Files\SH3 Commander-GWX"

After you've installed GWX use JSGME to enable any mods you like. Before enabling them make sure that
1. You're in port and NOT at sea
2. You have ROLLBACK SH3Cmdr (if you're using it)

Good Luck and if you need anything else just give us a shout :up: