Log in

View Full Version : SH3 won't let me finish training exam

Indiana_Jones
05-19-07, 10:50 PM
G'day.

1st post on this forum, just got SH3 about a week ago. Own SH1 and SH2 :up: . Might have to wait a little while for SH4, as my PC ain't quite upto it lol.

Anyways I have a problem, I've been trying to do the training exams, and I have done the 1st three. But when I try to do the forth, I can't complete it. I sink all the ships and then send a status report to base and all I keep getting in reply is "Keep up the good work!"

So I esc, return to base and it says "exan not done yet"

Driving me bonkers!

Any advice?

Cheers

-Indy
GoldenRivet
05-20-07, 12:22 AM
Using any mods? which exam is the fourth one?
Ottensen
05-20-07, 01:14 AM
G'day.

1st post on this forum, just got SH3 about a week ago. Own SH1 and SH2 :up: . Might have to wait a little while for SH4, as my PC ain't quite upto it lol.

Anyways I have a problem, I've been trying to do the training exams, and I have done the 1st three. But when I try to do the forth, I can't complete it. I sink all the ships and then send a status report to base and all I keep getting in reply is "Keep up the good work!"

So I esc, return to base and it says "exan not done yet"

Driving me bonkers!

Any advice?

Cheers

-Indy

Have you made sure you're doing the actual exam and not the unmarked test? I wasted hours wondering why I was an habitual failure doing that until I realised
Indiana_Jones
05-20-07, 02:19 AM
Yea I think that's what I might of been doing. I just edited the txt/data file to say i pass :p

Cheers

and doing evrything manually is a bitch lol

-Indy
Jimbuna
05-20-07, 04:40 AM
Welcome aboard kaleun....for the sake of a few renown points is it worth persevering ? :hmm:
Brag
05-20-07, 06:44 AM
Welcome aboard, Indy. Good luck with your carreer. :up:
_Seth_
05-20-07, 10:18 AM
welcome aboard, mate! :up:
danurve
05-20-07, 10:21 AM
Have you made sure you're doing the actual exam and not the unmarked test? I wasted hours wondering why I was an habitual failure doing that until I realised

I remember making the same error.
Maraz
05-20-07, 03:18 PM
Use F8 to check if the mission's objective (at least primary objectives) are completed.

Maraz