SH3 Commander stopped working - help!

Deep Six · 07-07-2005, 06:01 PM

Hi.......... Did you make a shortcut from your desktop to the SH3Cmdr application ??

I too had a funny results when trying to access the commander from the shortcut, it works but non of the pictures would work, including jpegs of medals and such.....

Now I just open up the folder where my commander is installed and run from there.....Works everytime....

Deep Six

JScones · 07-08-2005, 04:48 AM

Strange for that to happen - I run from a desktop shortcut (much easier that way) and never have problems. If you make sure the "Start in" folder is "C:\<InstallPath>\SH3 Commander" (including the quotes) you should be fine.

Oh, make sure you are running SH3 Commander v1.1.0 or greater. The latest version (v1.1.1) is available from Beery's site.

07-07-2005, 06:01 PM	#1
Deep Six Ace of the Deep Join Date: Mar 2002 Location: England, Manchester. Posts: 1,263 Downloads: 104 Uploads: 0	Hi.......... Did you make a shortcut from your desktop to the SH3Cmdr application ?? I too had a funny results when trying to access the commander from the shortcut, it works but non of the pictures would work, including jpegs of medals and such..... Now I just open up the folder where my commander is installed and run from there.....Works everytime.... Deep Six __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-08-2005, 04:48 AM	#2
JScones Navy Seal Join Date: Apr 2005 Posts: 5,564 Downloads: 19 Uploads: 0	Strange for that to happen - I run from a desktop shortcut (much easier that way) and never have problems. If you make sure the "Start in" folder is "C:\<InstallPath>\SH3 Commander" (including the quotes) you should be fine. Oh, make sure you are running SH3 Commander v1.1.0 or greater. The latest version (v1.1.1) is available from Beery's site.