You should to show screenshots of torpedo presets (before launching) because it is crucial for torpedo behaviour.
BTW, did you read RA_Weapon_Info_Rev38.pdf about AIR DROPPED TORPEDOES?
Quote:
Mk 50 Torpedo
Advanced Lightweight ASW Torpedo.
and
Mk 54 Torpedo
Advanced Lightweight Torpedo. (ASW/ASuW)
TORPEDO CONTROL:
Modes For SEARCH PATTERN - SNAKE.
" Left Side - Narrow SNAKE "
FLOOR: 01000 (By default)
SEARCH PATTERN: SNAKE
Key figure 0:
It will set to a torpedo such features - after sensor enabled the initial turn of a torpedo in the left sector. The amplitude of the snake narrow - a torpedo carries out a deviation on 30 degrees from preenable course. We admit a torpedo have started in 000 degrees, the ambassador of a beginning of performance of the snake the torpedo begins the left turn. When she will rise on a rate 330 - ( a deviation from the given preenable crs in 000 degrees - happened as 30 degrees) - the return turn in the right side begins. On a right shoulder, as soon as the rate of a torpedo will be 30 degrees - the return process - turn of a torpedo in the left side again on a rate 330 degrees etc.etc … to put it briefly snake cycle begins.
" Right Side - Narrow SNAKE "
FLOOR: 11000
SEARCH PATTERN: SNAKE
Key figure 1.
As well as in the previous mode - the initial turn is carried out in the right sector.
" Left Side - WIDE SNAKE "
FLOOR: 21000
SEARCH PATTERN: SNAKE
Key figure 2.
As well as in the First mode - the initial turn is carried out in the Left sector, with that difference, that the snake has increased snake amplitude - 45 degrees, as a consequence, a little wider range of viewing in lateral sectors.
" RIGHT Side - WIDE SNAKE "
FLOOR: 31000
SEARCH PATTERN: SNAKE
Key figure 3.
Analogue of a Previous mode with only turn in the right sector.
Modes for SEARCH PATTERN - CIRCLE.
" Left Side - Narrow CIRCLE "
FLOOR: 01000
SEARCH PATTERN: CIRCLE
After enabled sensor control, the turn of a torpedo in the left side on small radius begins.
" Right Side - Narrow CIRCLE "
FLOOR: 11000
SEARCH PATTERN: CIRCLE
After enabled sensor control, the turn of a torpedo in the right side on small radius begins.
" Left Side - WIDE CIRCLE "
FLOOR: 21000
SEARCH PATTERN: CIRCLE
After enabled sensor control, the turn of a torpedo in the Left side on large radius begins
Diameter of a ring about 1.2 miles. (For different torpedoes on any other diameter range - depends on value of minimal radius given to a torpedo in DataBase, and own speed.)
" Right Side - WIDE CIRCLE "
FLOOR: 31000
SEARCH PATTERN: CIRCLE
After enabled sensor control, the turn of a torpedo in the Right on large radius begins.
Additional Mode: DIRECT MOVE
Key figures: 32555
" DIRECT MOVE "
FLOOR: 32555
SEARCH PATTERN: ANY - CIRCLE Or SNAKE
After enabled, sensor control, the torpedo goes directly in preenable course. Any maneuver does not make, the sensor control scans ahead of a torpedo.
Note: O.H. Perry (the default preset FLOOR as 32766 will establish to a torpedo 3935ft - the maximal depth Mk 50 torpedo)
|