Quote:
|
Well what happened was that I turned to port after shooting up a JU88s port engine and the suddenly went into a stall and then into a flat spin. Even if prop wash isn't modeled in-game it sure seemed like an effect of prop wash.
|
Sounds to me as if you just had pulled a bit too hard. Looks like a normal stall with wrong recovery technique. In a stall go to idle throttle, centre aileron and elevator and give full counter rudder until the spinning stops. Wait for the plane to pick up speed again and then you should be good to go again.
A prop wash does not push you into a stall it makes your plane go bumpy but that's all (At least according to the glider pilots at my local airfield who sometimes get towed into the air behind a propeller driven plane.)
BTW
The blood soaked cockpits only work on a few older aircraft. Most aircraft have no blood modeled for them (unless some mod changed that).
