View Single Post
Old 02-01-13, 06:10 PM   #1351
Smurfie
Swabbie
 
Join Date: May 2012
Location: Smurf Galaxy
Posts: 7
Downloads: 46
Uploads: 0
Default

Quote:
Originally Posted by sober View Post
There is a lot of info in the stoianm tutorials
http://www.subsim.com/radioroom/showthread.php?t=181538
Here is how i plot a course for general travelling.
http://www.subsim.com/radioroom/show...79&postcount=4
Thanks for the links but I'm not sure you understood what i meant. Standard tool helper (as in your 2nd link) has its center on the tip of the line you draw with the ruler when you draw it, which means that you can tell the bearing as you draw that said line. My pic shows how the tool is placed constantly above the line while drawing it so i can't figure out what bearing it has unless i confirm it and move the bearing tool on top of it after that. Not that big of a problem, but i was curious what could have changed the way it normally works.

Edit: Aahh, nevermind. I hadn't noticed that although i installed EquaTool, i had the small standard helper for some reason, which is probably the cause. I pointed the mod enabler to your mep file to load the mods automatically, which leads to the next question. Seeing as something went wrong when installing that particular mod (got no warning of any kind), is it better to auto-load or manually load them one by one?

Last edited by Smurfie; 02-01-13 at 06:55 PM.
Smurfie is offline   Reply With Quote