@ Vecko
[UnitPart 1]
ID= VIIC41Tower1
Type= VIIC41ConningTower ;Can only placed on unit parts slot of this type
NameDisplayable= VIIC41c1-Conning-Name
Info=VIIC41c1-Conning-Info
Notes=VIIC41c1-Conning-Notes
UnitPartInterval=NULL, NULL
ExternalLinkName3D= Conning_7c41_01,data\Submarine\NSS_Uboat7c41\Subma rine Parts\Conning_7C41_01
HullTextureNameOverride=NULL
HullLightmapTextureNameOverride=NULL
HullNormalmapTextureNameOverride= NULL
MenuSilhouetteTextureNameOverride= data\Textures\TNormal\tex\7C.dds
ImageIndex=2
TrackingID=103
each sub has its own numbered unitspart file 7c41 is unitparts3VIIC41
I made a new file called unitparts6IXB (next number in sequence after last sub in list)
my changes for IXB
[UnitPart 1]
ID= IXBTower1
Type= IXBConningTower ;Can only placed on unit parts slot of this type
NameDisplayable= IXB-Conning-Name
Info=
Notes=
UnitPartInterval=NULL, NULL
ExternalLinkName3D= Conning_IXB_01,Data\submarine\NSS_UboatIXB\Submari ne Parts\Conning_IXB_01
HullTextureNameOverride=NULL
HullLightmapTextureNameOverride=NULL
HullNormalmapTextureNameOverride= NULL
MenuSilhouetteTextureNameOverride= NULL
ImageIndex=2
TrackingID=103............I ALSO TRIED WITH THE LAST 2 ENTRIES DELETED, MADE NO DIFFERENCE
I loaded SH5 and if it CTD, I just went and looked through all the files again for any I had missed, until it loaded. FYI....even 1 wrong/missed entry in a single file would cause CTD
going to run file access monitor when sh5 loads, see if it throws any light on the situation,
Last edited by mkiii; 11-13-17 at 02:56 PM.
|