OK, I'm trying this out, no luck so far.
Did a fresh install of SH3 using Direct2Drive version - installs as 1.4.0.1
Installed JSGME
Installed the following mods:
WarAceCampaign 5.0
WarAceCampaign 5.0 Patch_5.01
WAC5.0 Campaign_Atlantic_Baltic
02-Gauges v2
WAC5.0 Subpens_Ambient_Light
WAC5.x_smaller_waves
I used the V16B1-Patch-Kit to patch my SH3.exe, and then used the HsieOptionsSelector.exe to enable 4GB (though I do not know if any command line switch is needed to use this).
When I run the above, everything seems to work (full screen, too, on my GTX960 + 1920x1080 display), but when I try to load a Single Mission, like Happy Times, I get to about 90% on the load bar and it hangs.
If I try to use the WAC5.01 WideScreensGUI 1920x1080 Ahnerbe mod, then after the intro movie plays I get a black screen and eventually the menu music is playing but the screen stays black.
Any suggestions?
It sure would be nice to get a complete installation instruction tutorial including installation of WAC, all related mods, SH3 patching, h.sie configuration, and SH3 Commander installation. Right now the WAC installation tutorial only covers about 20% of the work to get a complete setup.
Steve
|