SUBSIM Radio Room Forums - View Single Post - How to attack Victor III armed with Shkval?

somedude88 · 04-08-18, 07:18 PM

In a user-made ASW tutorial mission, I have to sink a Victor III

If I launch from far, the Victor outruns the ADCAPs, if I launch any closer than 12nm,, I get nailed by Shkvals.

While I don't get sunk from the Shkvals, they always damages the tubes, preventing me from wire guiding them onto the Victor when it takes evasive maneuvers.

There is also an issue with the layer @ 1000 ft. The victor smartly goes beneath the layer to avoid the ADCAPs. I read in the "red book" on how to change depths of the torpedoes, but it doesn't seem to work.

Is there a way to reset the depth of the ADCAPs after they've been launched?

04-08-18, 07:18 PM	#1
somedude88 Torpedoman Join Date: Dec 2010 Posts: 120 Downloads: 54 Uploads: 0	How to attack Victor III armed with Shkval? In a user-made ASW tutorial mission, I have to sink a Victor III If I launch from far, the Victor outruns the ADCAPs, if I launch any closer than 12nm,, I get nailed by Shkvals. While I don't get sunk from the Shkvals, they always damages the tubes, preventing me from wire guiding them onto the Victor when it takes evasive maneuvers. There is also an issue with the layer @ 1000 ft. The victor smartly goes beneath the layer to avoid the ADCAPs. I read in the "red book" on how to change depths of the torpedoes, but it doesn't seem to work. Is there a way to reset the depth of the ADCAPs after they've been launched? Last edited by somedude88; 04-08-18 at 08:05 PM.