SUBSIM Radio Room Forums - View Single Post - This is how i operate the boat in single player .

THE_MASK · 03-15-19, 03:36 PM

Go to hydrophone .
Quote by Baal on the discord channel .
''You only use high/low pass to filter out sound of specific contacts you want to hear
low is best for picking up engine noise, and high is best for hearing screws
it's pretty finicky though, so it takes some fine tuning''
''also, if you have no reason to use high pass, just set it to 0
high pass pretty much just neutralized sound of contacts unless we were close enough to hear screws''

I set gain at around 2.5 to start off with .

03-15-19, 03:36 PM	#2
THE_MASK Ace of the deep . Join Date: Jan 2006 Posts: 9,226 Downloads: 901 Uploads: 73	Go to hydrophone . Quote by Baal on the discord channel . ''You only use high/low pass to filter out sound of specific contacts you want to hear low is best for picking up engine noise, and high is best for hearing screws it's pretty finicky though, so it takes some fine tuning'' ''also, if you have no reason to use high pass, just set it to 0 high pass pretty much just neutralized sound of contacts unless we were close enough to hear screws'' I set gain at around 2.5 to start off with .