After Upgrade 3D Stops and Restarts
Greetings folks,
Have scoured this forum for an answer to this issue without luck.
I have SH4 installed with all patches.
Ran fine until I recently upgraded from an Extreme P4 Pressler to an extreme Quad QX6800. I also upgraded from a 4850 to an ASUS 4870 Top. I suspect the problem somehow involved the ATI settings for the new graphics card.
Anyway, the game loads OK. However, as soon as I get into the sub (into 3D) after a few seconds the game freezes for 2 to 6 seconds and then starts again. It repeated does this. I.E. Runs for 5 seconds or so and then freezes for 5 seconds or so.
FYI, the temps on my grphics card are fine at around 55 deg C.
Should I uninstall/reinstall the game? Or, are there one or more ATI settings for .cfg settings I can tweak?
Any help would be appreciated.
Thanks in advance
Regards,
Alex Craig
MSI 975X Platinum 'Power Up' Edition
Intel Core 2 Extreme Edition QX6800 1066MHz FSB 2 x 4MB L2 Cache
2 Gig of 'Extreme Dominator' DDR2 RAM
ASUS R4870 Top Video Card
Antec 850 TRUEPOWER Quattro PSU
Realtek HD Audio
|