SUBSIM Radio Room Forums - View Single Post - [REL] sh4speech

moselgott · 08-02-07, 09:26 AM

Hi all, I´ve got a little problem, too!

I followed all the instructions and everything was fine so far. All installing, adjusting the microphone, no problem at all. But then I wanted to start the programm

( Run "sh4speech.bat" to start the program.

When you run it, it will open a new window that says "Listening for voice commands from voice_commands.csv".)

the window opens only for less than a second and immediately closes again. Nothing happens furtheron (I think I should be able to give to commands in SH4 then, but I´m not)

Does anyone know what I did wrong / can do now?

Thanks a lot, moselgott!

EDIT: Ok, I made that window run entering "hear.py" instead of "sh4speech.bat". So that window appears with the sentence "listening for phrases from voice_commands.csv", and commands like "map" or "dive" appear there if I speek into the microphone. So I started SH4 parallel to that window and gave several commands, but nothing happened. I went back to desktop and the window showed up with all the commands I gave while Sh ran. What do I do wrong!?!?!?
Any ideas?

08-02-07, 09:26 AM	#27
moselgott Watch Join Date: Apr 2006 Posts: 23 Downloads: 0 Uploads: 0	Hi all, I´ve got a little problem, too! I followed all the instructions and everything was fine so far. All installing, adjusting the microphone, no problem at all. But then I wanted to start the programm ( Run "sh4speech.bat" to start the program. When you run it, it will open a new window that says "Listening for voice commands from voice_commands.csv".) the window opens only for less than a second and immediately closes again. Nothing happens furtheron (I think I should be able to give to commands in SH4 then, but I´m not) Does anyone know what I did wrong / can do now? Thanks a lot, moselgott! EDIT: Ok, I made that window run entering "hear.py" instead of "sh4speech.bat". So that window appears with the sentence "listening for phrases from voice_commands.csv", and commands like "map" or "dive" appear there if I speek into the microphone. So I started SH4 parallel to that window and gave several commands, but nothing happened. I went back to desktop and the window showed up with all the commands I gave while Sh ran. What do I do wrong!?!?!? Any ideas? __________________ "War does not determine who´s right, only who´s left" - Bertrand Russel Last edited by moselgott; 08-02-07 at 09:56 AM.