SUBSIM Radio Room Forums - View Single Post - LIVING SILENT HUNTER III EDITION 2015

siege00 · 02-11-16, 10:05 AM

Yeah. The OLC interface was primarily designed for pure manual targeting using the scope wheels and accepting input into the TDC controls that appear when clicking the switch.

You can find OLC's video tutorials here which are really good: http://www.subsim.com/radioroom/down...o=file&id=1112

Tailmange did a pretty good video on Youtube using OLC GUI, not exactly the same as the LSH3 interface but pretty close:

I've discovered that the only differences between the videos and the LSH implementation is that the recognition manual is different and where the controls show up is different (I think OLC vid matches). When using the rings, when you get the mast height in marks, you have to compare it against 2x the mast height listed in the recog manual (OLC's mast heights were actually doubled in his recognition manual IIRC) ie. master height is 23.1 then you would compare against 46.2, and reading only half of the horizontal marks to determine AOB. You can practice this in the torpedo training mission to confirm. In OLC's vid he also shows how he uses the Attack Disk.

02-11-16, 10:05 AM	#401
siege00 Officer Join Date: Aug 2010 Location: USA Posts: 237 Downloads: 114 Uploads: 0	Yeah. The OLC interface was primarily designed for pure manual targeting using the scope wheels and accepting input into the TDC controls that appear when clicking the switch. You can find OLC's video tutorials here which are really good: http://www.subsim.com/radioroom/down...o=file&id=1112 Tailmange did a pretty good video on Youtube using OLC GUI, not exactly the same as the LSH3 interface but pretty close: I've discovered that the only differences between the videos and the LSH implementation is that the recognition manual is different and where the controls show up is different (I think OLC vid matches). When using the rings, when you get the mast height in marks, you have to compare it against 2x the mast height listed in the recog manual (OLC's mast heights were actually doubled in his recognition manual IIRC) ie. master height is 23.1 then you would compare against 46.2, and reading only half of the horizontal marks to determine AOB. You can practice this in the torpedo training mission to confirm. In OLC's vid he also shows how he uses the Attack Disk.