Question regarding patching.
Is it advisable to first disable al my mods, before patching, and then after patching enable all my mods again? Or doesn't it really matter?
Also do I still have to edit the menu.txt manually with the follwing:
Code:
Required menu.txt entries for versions >= v1.0.74.0:
Edit this line in your menu.txt file:
MaxStrings=11100
Add these to the end of your menu.txt file:
; Independent engine controls patch
10025=Shafts
10026=Click to enable/disable speed commands for the port shaft
10027=Click to enable/disable speed commands for the starboard shaft
; Contact report wolfpack patch
11000=Dispatching available submarines to your patrol area|Remain undetected and in a favorable position|Send status reports| |Bdu
11001=All available submarines have been dispatched to your patrol area
11002=Submarines in your area have received instructions to join your attack|Stay in front of contact/convoy, remain undetected, and send regular status reports| | |B.d.u
11003=Remain undetected and continue following contact/convoy|Available submarines are heading to your patrol area
11004=Attain favorable position and shadow contact/convoy until reinforcements arrive
; possible messages from Bdu when can not dispatch subs
11010=No boats are within your patrol area|Act as lone boat| |Bdu
11011=No support within range|Be more aggressive| |Bdu
11012=Contact report received|Act on own data| |BdU
11013=Be more aggressive!| |Bdu
11014=Attack contact| |Bdu
; Reports from dispatched subs
11020=Contact keeper continue to send bearing signals|Group act on own data|Take every opportunity to attack
11021=Convoy in sight|Signal bearing sent|Moving to attack port side
11022=I believe to have made contact with the convoy|Sending bearing signals|Act according to own data|Attacking at full speed
11023=Requesting bearing signal from contact keeper
11024=Beacon signals lie in the line of approach according to dead reckoning.|Attacking far side of convoy