mouse problem sh3
 

I use win 7 64bit so I had to use win 7 32bit via a Desktop and Application Virtualization like VMware
Specs
i5 6600k
16 gb ram
rx470 (ATI)

The mouse in any view is horrific.
Specifically
if you move the mouse,
a little to the left, view shifts 50-60 degrees to the left.
a little to the right, view shifts 50-60 degrees to the left.
Yes, you read correctly.
More to the right, view shifts 100 degrees to the right.
little to the left, view shifts 50-60 degrees to the right.
And so on.
a lot to either left or right, view shifts 720 degrees in either direction.
little forward, view shifts 300 degrees upward
little back, view shifts 300 degrees downwards.
I request your help.

Your mouse DPI is redicoulisly high. It's going to depend on your mouse as to if you can change it.

probably, because the label is torn, is this... http://www.konigelectronic.com/fr_be/978360

Well it's certainly not DPI as 400 isn't that high. And your mouse can't have it changed like the high-end mice can.

Sorry I couldn't be of more help.

Also, SH3 runs in windows 7 64bit.

In win 64 it reports "cannot initialize 3d engine"
Thank you for your contribution, at least.
Could you clarify on this thread?
http://www.subsim.com/radioroom/showthread.php?t=176708
"Left ctrl make a moves slower
left shift make a moves faster"

welcome aboard!
 

:Kaleun_Salute:

@atsimas

Regarding the 3d engine problem see this thread;

http://www.subsim.com/radioroom/show...+initialize+3d

also this;

http://www.subsim.com/radioroom/show...33&postcount=6

I recommend running SH in a 64 bit enviroment as this will help when you eventually start using the bigger mods.

Hope this helps, and welcome to subsim.

Fubar2Niner

with directx 11, I changed the refresh rate from 59 to 60 hz and it works
(win 7 64).
Not only that, but the mouse also works fine.

Glad you got it sorted shipmate :salute:

Regards.

Fubar